KMFS Vantaedge integral

KMFS Vantaedge integral

The KMFS Vantaedge integral grinding system is the latest evolution of grinding systems.Patented grinding system solution completely developed and manufactured in the Czech Republic.This grinding system is the first in the world to completely eliminate the effect of the raised facet at the tip of the knife and enables absolutely precise repeated sharpening of the knife without any demands to repeat the knife clamping position.

The biggest change compared to all grinding systems is the introduction of reverse kinematics, where the system, based on the exact angle on the blade, adjusts the other components of the set so that the angle on the blade is always the same regardless of the depth of the knife clamping. The grinding system in the basic assembly includes a head with grinding angles of 15°, 17.5°, 20°, 22.5°, which are precisely observed along the entire blade and with each grinding. The set's additional accessories enable grinding of other angles as well.

Thanks to the Integral clamp (chassis) completely milled from a block of Ergal 7075 T651 material, a perfectly precise clamping orientation of the knife is achieved, maximum strength and easy clamping. This is made possible by a double clamping clamp equipped with spherical bronze bushings of the clamping screws, which eliminate unwanted clamping forces and enable perfect adaptation to the knife blade. It is not necessary to clamp the blade in both jaws when clamping the knife, even just one jaw provides sufficient clamping for grinding. The maximum thickness of the knife blade 7.5-8 mm, the maximum length of the blade sharpened not one clamping 20-25 cm (the knife can be clamped several times during one sharpening without any problems)

The KMFS Vantaedge integral clamp is symmetrical and by simply turning it, it is possible to sharpen the other side of the knife without having to rotate the knife in the clamp. The set is completely equipped with ball bearings for absolutely smooth operation without backlash. There are 4 pieces of fully shielded bearings for rotation about two angular axes and 3 pieces of double linear four-row bearings. The set has a grinding stone holder that is able to clamp all KMFS Rival stones and most stones from other manufacturers, when there is no problem with the transition of the abrasive, there is no need to adjust the set in any way for a different thickness of the abrasive, the kinematics always reaches the right angle. The clamping segment of the stone, held by a stainless steel spring, has integrated brass pins to protect the hand against contact with the knife edge during sharpening. At the same time, the control wings of the segment enable precise guidance of the grinding stone.

Grinding is possible either by placing the integral clamp on the stand supplied in the package, or it is possible to grind only by holding the integral clamp in the hand (advantageous when there is no table when grinding, for example outdoors) The package contains:

- plastic waterproof suitcase with foam organizer

- grinding system KMFS Vantaedge integral

- Stand for setting up the integral clamp

- the price includes 1 piece of grinding diamond 240 grit with DLC treatment

- the price includes 1 piece of grinding diamond 600 grit with DLC treatment

- the price includes 1 piece of grinding diamond 1000 grit with DLC treatment

- Allen keys for assembling the stand, clamping the knife and tightening the segment of guide rods on the angle head - FP-10 Lubricant Elite oil for system maintenance